Front Door Window Regulator: Service and Repair
Front Side Door Window Regulator ReplacementRemoval Procedure
1. Remove the front door outside handle.
2. Remove the front door window run channel assembly.
3. Remove the front door lower speaker.
4. Disconnect the mirror electrical connector.
5. Disconnect the 4 electrical connector rosebuds (2 at the mirror and 2 under the speaker).
6. Loosen the 2 rear module bolts.
7. Remove the 4 remaining module bolts.
8. Remove the 3 latch bolts from the door shut face.
9. Disconnect the door harness at the door jamb.
10. Remove the window regulator module from the door.
Installation Procedure
1. Install the window regulator module into the door.
2. Connect the door harness at the door jamb.
CAUTION: Refer to [Fastener Notice] in Cautions and Notices.
3. Install the 3 latch bolts to the door shut face.
Tightening torque
Tighten the bolts to 10 N.m (89 lb in).
4. Install the 4 module bolts.
Tightening torque
Tighten the bolts to 8 N.m (71 lb in).
5. Connect the 4 electrical connector rosebuds (2 at the mirror and 2 under the speaker).
6. Connect the mirror electrical connector.
7. Install the front door lower speaker.
8. Install the front door window run channel assembly.
9. Install the front door outside handle.