Air Cleaner Housing: Service and Repair

Air Cleaner Assembly Replacement

Removal Procedure





1. Remove the air cleaner outlet duct.
2. Disconnect the engine wiring harness electrical connector from the mass air flow (MAF)/intake air temperature (IAT) sensor.





3. Remove the air cleaner bolt.
4. Disengage the air cleaner pins from the front panel and remove the air cleaner assembly.
5. If replacing the air cleaner assembly, remove the VAF/IAT sensor.

Installation Procedure





1. If the air cleaner assembly was replaced, install the MAF/IAT sensor.
2. Install the air cleaner assembly by inserting the two pins into the front panel.

CAUTION: Refer to [Fastener Notice].

3. Install the air cleaner bolt.
Tightening torque
Tighten the bolt to 10 N-m (89 in. lbs.).





4. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
5. Install the air cleaner outlet duct.