4-5 Clutch Drum Assembly Assemble
4-5 Clutch Drum Assembly AssembleSpecial Tool
J 23327 Clutch Spring Compressor
J 25024-A Servo Piston/Clutch Spring Compressor
J 28585 Snap Ring Remover
J 45186 Forward and Direct Clutch Spring Compressor
NOTE:
Soak the new clutch discs in automatic transmission fluid for at least 2 hours before installation.
1. Apply automatic transmission fluid to the new piston seals.
2. Install a new piston inner seal (581) and a new piston outer seal (583) on to the 4-5 clutch piston (582).
3. Apply automatic transmission fluid to the inner and outer seal surfaces of the 4-5 clutch drum assembly (584).
4. Install the 4-5 clutch piston assembly (582) into the 4-5 clutch drum assembly (584).
5. Install the 4-5 clutch piston return spring assembly (580) on to the 4-5 clutch piston assembly, indexing the springs to the holes in the 4-5 clutch piston assembly.
NOTE:
Make sure that the end gap of the retaining ring is not aligned with the spring retainer claw.
6. Install the 4-5 clutch piston return spring retaining ring (579).
a. Place the J 25024-A (3) in a vise with the forcing screw on the bottom and backed out.
b. Place the 45186 (1) on the 4-5 clutch piston return spring assembly (580).
c. Place the J 21420-2 (4) from the J 23327 on top of the forcing screw of J 25024-A (3).
d. Place the clutch housing with the J 45186 (1) on the J 21420-2 (4) and under the arms of J 25024-A (3).
e. With the forcing screw, compress the clutch spring to allow the installation of the retaining ring.
f. Use J 28585 (2) or snap ring pliers to install the retaining ring (579).
NOTE:
Make sure that you have the correct number of plates, and that they are in the correct order.
7. Install the 4 fiber plates (577) and the 4 steel plates (578) into the 4-5 clutch drum assembly (584).
8. Install the 4-5 clutch backing plate (576) into the 4-5 clutch drum assembly (584).
9. Using J 28585 install the 4-5 clutch backing plate retaining ring (575) into the groove of the 4-5 clutch drum assembly (584). Make sure that the end gap of the retaining ring is not aligned with one of the cutouts in the drum.