Transaxle Fluid Replacement

Transaxle Fluid Replacement

Removal Procedure





1. Raise and support the vehicle.
2. Remove the drain plug and drain fluid. Allow at least 5 minutes for the fluid to drain completely.
3. Remove the gasket from the drain plug and discard.

Installation Procedure





1. Install the new gasket on the drain plug.

CAUTION
Refer to [Fastener Notice.]

2. Install the drain plug.
Tightening torque
Tighten the drain plug to 40 Nm (30 ft. lbs.)
3. Make sure vehicle is level.
4. Remove the fluid level indicator located behind the front transaxle mount.

CAUTION
Do not remove the 3rd gear anchor and bolt located on top of the transmission for checking fluid or adding fluid. Removing the bit will dislocate internal components and require the transmission to be removed from the vehicle and disassembled for repair.

NOTE:
Dexron (R)III automatic transmission fluid is not compatible with this transaxle. If Dexron (R)III ATF is used, transaxle failure will result.

5. Add approximately 3.1 L (3.3 Qt) of GM T-IV fluid to the transaxle, using the fluid level indicator location.

NOTE:
If the check is necessary at a low oil temperature of 3046 304°C (810°F) perform check using the COLD range on the level gage. However the fluid must la re-checked at the proper fluid temperature.

6. Start engine and operate vehicle until transaxle fluid temperature reaches 60-70°C (140-158°F).
7. Apply parking brake.
8. Depress brake pedal and move shift lever slowly through all gear ranges from park (P) to low (L), pausing for about 3 seconds in each range. Return shift lever to park (P) range at idle condition.
9. Pull level gauge out again and check if fluid level is within the HOT range.
10. If fluid is not within the correct level, adjust accordingly:
a. If fluid is below the HOT range, add enough to bring it up to the correct level.
b. If fluid is above HOT range, drain excess fluid.
11. Install the fluid level indicator.