Engine: Specifications
GENERAL SPECIFICATIONS
DRIVE BELT
INTAKE MANIFOLD COLLECTOR, INTAKE MANIFOLD AND EXHAUST MANIFOLD
SPARK PLUG
CAMSHAFT AND CAMSHAFT BEARING
Valve Seal
Valve Lifter
Valve Clearance
Available Valve Lifter
VQ40DE
CYLINDER HEAD
Valve Dimensions
Valve Guide
Valve Seat
Valve Spring
Spark Plug Tube
CYLINDER BLOCK
PISTON, PISTON RING AND PISTON PIN
Available Piston
Piston Ring
Piston Pin
CONNECTING ROD
CRANKSHAFT
MAIN BEARING
Undersize
Main Bearing Oil Clearance
CONNECTING ROD BEARING
Undersize
Connecting Rod Bearing Oil Clearance
Camshaft bracket bolts
Step 1 (bolts 7 - 10) :1.96 N-m (0.2 kg-m, 17 in-lb)
Step 2 (bolts 1 - 6) :1.96 N-m (0.2 kg-m, 17 in-lb)
Step 3 :5.88 N-m (0.6 kg-m, 52 in-lb)
Step 4 :10.4 N-m (1.1 kg-m, 92 in-lb)
Cylinder Head bolt
If cylinder head bolts re-used, check their outer diameters before installation.
Step a :98 N-m (10 kg-m, 72 ft-lb)
Step b :Loosen to 0 N-m in the reverse order of tightening.
Step c :39.2 N-m (4.0 kg-m, 29 ft-lb)
Intake manifold bolt and nuts
1st step :7.4 N-m (0.75 kg-m, 65 in-lb)
2nd step and after :29.0 Nm (3.0 kg-m, 21 ft-lb)
Oil pan upper 22.0 N-m (2.2 kg-m, 16 in-lb)
Oil pan lower 9.0 N-m (0.92 kg-m, 80 in-lb)
Oil pump 6.9 N-m (0.7 kg-m, 61 in-lb)
Tighten lower cylinder block as follows:
Tighten M8 bolts in numerical order as shown from No. 17 to 24.
Bolts 17- 24 :22.1 N-m (2.3 kg-m, 16 ft-lb)
Step 1: Tighten M10 bolts in numerical order.
Bolts 1 - 16: 35.3 N-m (3.6 kg-m, 26 ft-lb)
Step 2: Turn M10 bolts 90° clockwise in numerical order.
Connecting rod bolt: 19.6 N-m (2.0 kg-m, 14 ft-lb)
Then tighten all connecting rod bolts 90° clockwise.
Water Pump bolt 9.6 N-m (0.98 kg-m, 85 ft-lb)
Tighten bolts alternately and evenly
Tighten crankshaft pulley bolt in two steps.
Step 1 : 44.1 N-m (4.5 kg-m, 33 ft-lb)
Step 2 : 84 - 90 degrees clockwise
Drive plate 88.0 N-m (9.0 kg-m, 65 ft-lb)
Tighten bolts in a diagonal pattern in two steps