Removal and Replacement
Transmitter (Pressure Sensor): Removal And InstallationREMOVAL
1. Remove wheel and tire using power tool.
2. Deflate tire. Unscrew transmitter retaining nut and allow transmitter to fall into tire.
3. Gently bounce tire so that transmitter falls to bottom of tire. Place wheel and tire assembly on tire changing machine and break both tire beads. Ensure that the transmitter remains at the bottom of the tire while breaking the bead.
4. Turn tire so that valve hole is at bottom, and gently bounce the tire to ensure transmitter is near valve hole. Carefully lift tire onto turntable and position valve hole (and transmitter) 270 degrees from mounting/dismounting head.
5. Lubricate tire well, and remove top side of tire. Reach inside the tire and remove the transmitter.
6. Remove the second side of the tire as normal.
INSTALLATION
1. Place first side of tire onto rim.
2. Apply suitable silicone lubricant to new transmitter seal then install seal on transmitter. Refer to [Recommended Fluids and Lubricants].
NOTE: Always replace the seal after every disassembly.
3. Mount transmitter on wheel rim and tighten nut.
NOTE: Make sure no burrs exist in the valve stem hole of the wheel.
Transmitter nut tightening torque : 7.7 N.m (0.79 kg-m, 68 inlb)
4. Place wheel on turntable of tire machine. Ensure that transmitter is 270 degrees from mounting/dismounting head.
NOTE: Do not touch transmitter with mounting head.
5. Lubricate tire well, and install second side of tire as normal. Ensure that tire does not rotate relative to rim.
6. Inflate tire and balance the wheel and tire assembly. Refer to [Balancing Wheels].
7. Install wheel and tire assembly in appropriate wheel position on vehicle.
NOTE: If replacing the transmitter, then transmitter wake up operation must be performed. Refer to [Transmitter Wake Up Operation].
8. Adjust neutral position of steering angle sensor. Refer to [Adjustment of Steering Angle Sensor Neutral Position].