M/T Oil Changing [FS5R30A]

M/T Oil Changing [FS5R30A]

DRAINING
1. Start the engine and let it run to warm up the transmission.
2. Stop the engine. Remove the transmission drain plug and drain the oil.
3. Set a gasket on the drain plug and install it to the transmission. Tighten the drain plug to the specified torque. Refer to [Transmission Assembly: Disassembly and Assembly].

CAUTION: Do no reuse gasket.

FILLING
1. Remove the filler plug. Fill with new oil until oil level reaches the specified limit near the filler plug hole.






Oil grade and Viscosity: Refer to [Recommended Fluids and Lubricants].
Oil capacity: Refer to [Recommended Fluids and Lubricants].

2. After refilling the oil, check oil level. Set a gasket to the filler plug, then install it to the transmission. Tighten the filler plug to the specified torque. Refer to [Transmission Assembly: Disassembly and Assembly].

CAUTION: Do not reuse gasket.