Control Module: Service and Repair
Transfer Control Unit: Removal and InstallationREMOVAL
1) Switch 4WD shift switch to 2WD and set transfer assembly to 2WD.
CAUTION:
When removing transfer control unit, transfer state must be at 2WD.
2) Turn the ignition switch OFF and disconnect negative battery terminal.
3) Remove the lower instrument panel LH.
4) Disconnect the two transfer control unit connectors.
5) Remove the transfer control unit bolts.
6) Remove the transfer control unit.
INSTALLATION
Installation is in the reverse order of removal.
^ When installing the transfer control unit, tighten bolts to the specified torque.
Transfer control unit bolts :3.4 Nm (0.35 kg-m, 30 in-lb)
^ After the installation, check 4WD shift indicator pattern. If NG, adjust position between transfer assembly and transfer control unit.