Front

Front Wheel Speed Sensor Removal and Installation

Removal
1) Disconnect negative cable from battery.
2) Disconnect front wheel speed sensor coupler (1).
3) Hoist vehicle and remove wheel.
4) Remove harness clamp, clamp bolts (2) and grommet (3).
5) Remove front wheel speed sensor (4) from knuckle.

CAUTION:
^ Do not pull wire harness when removing front wheel speed sensor.
^ Do not cause damage to surface of front wheel speed sensor and do not allow dust, etc. to enter its installation hole.





Installation

1) Check that no foreign material is attached to sensor (1) and mating encoder (2).
2) Install it by reversing removal procedure.
Tightening torque
Front wheel speed sensor bolt (a): 11 Nm (1.1 kg-m, 8.5 ft. lbs.)
Front wheel speed sensor harness clamp bolt (b): 11 Nm (1.1 kg-m, 8.5 ft. lbs.)

CAUTION:
Do not pull or twist wire harness more than necessary when installing front wheel speed sensor.

3) Check that there is no clearance between sensor and knuckle.