4-Speed Automatic Transmission

Transmission Fluid Temperature Sensor Removal and Installation

Removal
1) Perform Step 1) to 7) of Solenoid Valves (Shift Solenoid-A, Shift Solenoid-B, Shift Solenoid-E, TCC Pressure Control Solenoid, Pressure Control Solenoid-A, Pressure Control Solenoid-B and Pressure Control Solenoid-C) Removal and Installation:5 A/T.
2) Remove transmission fluid temperature sensor (8).
3) Disconnect shift solenoid-A connector (1), shift solenoid-B connector (2), shift solenoid-E connector (3), TCC pressure control solenoid connector (4), pressure control solenoid-A connector (5), pressure control solenoid-B connector (6) and pressure control solenoid-C connector (7).
4) Remove solenoid valves.





5) After removing bolt (1) pull out solenoid connector (2) from transmission case.

CAUTION:
When pulling solenoid wire harness out of transmission case, take care not to damage connectors and transmission fluid temperature sensor at narrow exist of case. Careless sensor treatment might cause sensor malfunction.





Installation

Remove removal procedure to install transmission fluid temperature sensor, noting the following points.
^ For details of solenoid valves and their connectors installation, refer to Automatic Transmission Unit Assembly:5 A/T. Use new O-ring.
^ For details of A/T oil pan installation, refer to Automatic Transmission Unit Assembly:5 A/T.
^ Tighten exhaust No.1 pipe bolts & nuts.
^ Fill A/T fluid and check fluid level according to procedure described in A/T Fluid Change:5 A/T.
^ Check for fluid leakage after warming up A/T.