Component Tests and General Diagnostics

Rear End Door Window Defogger Wire Inspection

NOTE:
- When cleaning rear end door window glass, use a dry cloth to wipe it along heat wire (1) direction.
- When cleaning glass, do not use detergent or abrasive-containing glass cleaner.
- When measuring wire voltage, use a tester with positive probe (2) wrapped with a tin foil (3) which should be held down on wire by finger pressure.







Wire Damage Inspection

1. Start engine.
2. Turn on defogger switch.
3. Measure voltage at the center of each defogger wire (1), and check defogger wire condition according to the following table.
If defogger wire open is found, go to next step.

Defogger wire voltage










4. Touch voltmeter negative (-) lead to defogger wire ground terminal end (1).
5. Touch voltmeter positive (+) lead with a foil strip to defogger wire power source terminal end (2), then move it along wire to defogger wire ground terminal end (1).
The place where voltmeter fluctuates from 10 - 12 V to 0 - 1 V is where there is open.
If found defective, repair defogger wire referring to Rear End Door Window Defogger Wire Repair.