Contact Coil Cable Assembly Removal and Installation
Contact Coil Cable Assembly Removal and InstallationCAUTION:
Do not turn contact coil cable assembly more than allowable number of turns (about two and a half turns from the center position clockwise or counterclockwise respectively), or coil will break.
Removal
1) Remove steering wheel from steering column.
2) Remove steering column hole cover (1).
3) Remove steering column cover screws (1) (3 pieces).
4) Separate upper cover (2) and lower cover (3), then remove them.
5) Disconnect all connectors for contact coil cable assembly.
6) Remove contact coil cable assembly (1) with steering angle sensor (if equipped) from steering column.
7) Separate steering angle sensor from contact coil cable assembly.
Installation
1) Check to make sure that vehicle's front tires are set at straight-ahead position and then ignition switch is at "LOCK" position.
2) (ESP(R) model) Install steering angle sensor to contact coil cable assembly.
3) Install contact coil cable assembly to steering column nothing the following.
^ Fit lower fitting part first and then fit upper fitting part.
NOTE:
New contact coil cable assembly is supplied with contact coil cable assembly set and held at its center position with a lock pin (1). Remove this lock pin after installing contact coil cable assembly to steering column.
4) Connect all connectors that have been removed in "Removal".
5) Install steering column upper cover (2) and lower cover (3), and then tighten steering column cover screws (1).
CAUTION:
When installing lower cover (3) and upper cover (2), be careful so that each lead wire is not caught between covers.
6) Install steering column hole cover (1).
7) Install steering wheel to steering column.