Planetary Gears and Output Shaft Inspection

Planetary Gears and Output Shaft Inspection

^ Check that sliding surface of discs and plate are not worn or burnt. If necessary, replace them.

NOTE:
^ If disc lining is exfoliated, discolored or worn hardly, replace all discs.
^ If only a part of printed numbers is corroded, replace all discs.
^ Before assembling new discs, soak them in A/T fluid for at least 2 hours.





^ Measure inside diameter of output shaft bushing. If inside diameter exceeds limit, replace output shaft.

Output shaft bushing inside diameter standard
18.001 - 18.026 mm (0.7087 - 0.7097 in.)