Clearing Diagnostic Trouble Codes

DTC Clearance
1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector (DLC) (1) located on underside of instrument panel.
Special Tool
(A): SUZUKI scan tool (SUZUKI-SDT)





3) Turn ignition switch to ON position.
4) Erase DTC according to instructions displayed on SUZUKI scan tool. Refer to SUZUKI scan tool operator's manual for further details.
5) After completing clearance, turn ignition switch OFF and disconnect SUZUKI scan tool from data link connector (DLC)
6) Perform DTC Check. Motor-Shift Type (Transfer with Shift Actuator) and confirm that NO CODES is displayed. With Manufacturer's Scan Tool

NOTE:
DTC and freeze frame data stored in 4WD control module memory are also cleared in the following cases. Be careful not to clear them before keeping their record.
^ When power to 4WD control module is cut off (by disconnecting battery cable, removing fuse or disconnecting 4WD control module connectors).
^ When the same malfunction (DTC) is not detected again during 40 engine warm-up cycles.