Keyless Entry Receiver: Service and Repair

Remote Keyless Entry Receiver: Removal and Installation

Removal
1. Remove the front pillar upper finisher (RH). Refer to [Body Side Trim: Component].
2. Remove the side ventilator grille (RH). Refer to [Instrument Panel Assembly: Exploded View].
3. Remove the upper glove box. Refer to [Instrument Panel Assembly: Exploded View].
4. Remove cluster lid D. Refer to [Instrument Panel Assembly: Exploded View].
5. Remove the bolt (A), disconnect the harness connector (1) and remove the remote keyless entry receiver (2).






Installation
Installation is in the reverse order of removal.
- Perform TPMS ID registration. Refer to [ID Registration Procedure].