Procedures
Additional Service When Replacing Control Unit
Description
Memory Reset Procedure
1) Please observe the following instructions at confirming the sunroof operation.
NOTE:
Do not disconnect the electronic power while the sunroof is operating or within 5 seconds after the sunroof stops (to wipe-out the memory of lid position and operating friction).
2) Initialization of system should be conducted after the following conditions.
- When the battery has been disconnected or discharged.
- When the sunroof motor has been disconnected from power.
- When the sunroof motor is changed.
- When the sunroof does not operate normally (Incomplete initialization conditions).
Special Repair Requirement
Initialization Procedure
If the sunroof does not close or open automatically, use the following procedure to return sunroof operation to normal.
1 Turn ignition switch ON.
2 Push and hold the sunroof tilt switch in the forward (DOWN) position until the sunroof is fully closed.
3 After the sunroof has closed all the way, push and hold the tilt switch forward (DOWN) again for more than 2 seconds to re-learn motor position.
4 Initialization is complete if the sunroof operates normally.
Anti-Pinch Function
1 Fully open the sunroof.
2 Place a piece of wood near fully closed position.
3 Close the sunroof completely with auto-slide close.
Check that sunroof lowers for approximately 150 mm (5.91 in) or 2 seconds without pinching a piece of wood and stops.
CAUTION:
- Do not check with hands and other part of body because they may be pinched. Do not get pinched.
- Depending on environment and driving conditions, if a similar impact or load is applied to the sunroof it may lower.
- Check that auto-slide operates before inspection when system initialization is performed.
- Perform initial setting when auto-slide operation or anti-pinch function does not operate normally.