Valve Clearance: Service and Repair

Camshaft Valve Clearance

Inspection

Perform the following inspection after removal, installation or replacement of camshaft or valve-related parts, or if there are unusual engine conditions due to changes in valve clearance over time (starting, idling or noise).
1) Remove rocker cover. Refer to [Rocker Cover: Removal and Installation] Removal and Installation.
2) Remove engine under cover. Refer to [Front Bumper: Removal and Installation] Service and Repair.
3) Remove radiator shroud (lower). Refer to [Radiator: Exploded View] Exploded View.
4) Measure the valve clearance as follows:
a) Set No. 1 cylinder at TDC of its compression stroke.
- Rotate crankshaft pulley clockwise and align TDC mark to timing indicator on front cover.





- Make sure that intake and exhaust cam noses of No. 1 cylinder are located as shown.





- If not, rotate crankshaft one revolution (360°) and align as shown.
b) Use a feeler gauge to measure the clearance between valve lifter and camshaft.





Valve clearance:

Unit: mm (in)






1: Approximately 20 °C (68 °F)

2: Approximately 80 °C (176 °F)
- Measure the valve clearances at locations marked "x" as shown in the table below (locations indicated with black arrow shown) with feeler gauge.





- No. 1 cylinder compression TDC






c) Rotate crankshaft one revolution (360°) and align TDC mark to timing indicator on front cover.





- Measure the valve clearance at locations marked "x" as shown in the table below (locations indicated with black arrow shown) with feeler gauge.





- No. 4 cylinder compression TDC






5) If out of standard, perform adjustment.

Adjustment

- Perform adjustment depending on selected head thickness of valve lifter.

1) Measure the valve clearance.
2) Remove camshaft. Refer to [Camshaft: Removal and Installation] Removal and Installation.
3) Remove valve lifters at the locations that are out of the standard.
4) Measure the center thickness of the removed valve lifters with a micrometer.





5) Use the equation below to calculate valve lifter thickness for replacement.






- Thickness of new valve lifter can be identified by stamp marks on the reverse side (inside the cylinder).





Stamp mark "696" indicates 6.96 mm (0.2740 in) in thickness.

NOTE:
Available thickness of valve lifter: 26 sizes range 6.96 to 7.46 mm (0.2740 to 0.2937 in) in steps of 0.02 mm (0.0008 in) (when manufactured at factory). Refer to [Service Data and Specifications] [1][2]Specifications.

6) Install the selected valve lifter.
7) Install camshaft. Refer to [Camshaft: Removal and Installation] Removal and Installation.
8) Manually rotate crankshaft pulley a few rotations.
9) Make sure that the valve clearances for cold engine are within specifications by referring to the specified values.
10) Installation of the remaining components is in the reverse order of removal.
11) Start the engine, and check for unusual noise and vibration.