Seals and Gaskets: Service and Repair

Rear Oil Seal: Removal and Installation

Removal

1) Remove rear propeller shaft. Refer to [Propeller Shaft: Removal and Installation] 2S1330 Type (2S1330), [Rear Propeller Shaft: Removal and Installation] 3S1310 Type (3S1310), [Rear Propeller Shaft: Removal and Installation] 3S1330 Type (3S1330), [Rear Propeller Shaft: Removal and Installation] 3S1330-2BJ100 Type (3S1330-2BJ100).
2) Remove transfer from transmission (4WD models). Refer to [Transfer Assembly: Removal and Installation] (TX15B).
3) Remove rear oil seal using a suitable tool.






CAUTION:
Do not scratch rear extension assembly (2WD models) or adapter case assembly (4WD models).

Installation

1) Install new rear oil seal until it is flush into the rear extension case (2WD models) using Tool or adapter case (4WD models) using suitable tool.











CAUTION:
- Apply ATF to rear oil seal.
- Do not reuse rear oil seal.

2) Install transfer to transmission (4WD models). Refer to [Transfer Assembly: Removal and Installation] (TX15B).
3) Install rear propeller shaft. Refer to [Propeller Shaft: Removal and Installation] 2S1330 Type (2S1330), [Rear Propeller Shaft: Removal and Installation] 3S1310 Type (3S1310), [Rear Propeller Shaft: Removal and Installation] 3S1330 Type (3S1330), [Rear Propeller Shaft: Removal and Installation] 3S1330-2BJ100 Type (3S1330-2BJ100).
4) Check the A/T fluid level and for fluid leaks. Refer to [Checking the A/T Fluid (ATF)] Checking the A/T Fluid (ATF).