Seals and Gaskets: Service and Repair

Rear Oil Seal: Removal and Installation

Removal

1) Remove the rear propeller shaft. Refer to [Propeller Shaft: Removal and Installation] 2S1330 Type.





2) Remove the rear oil seal using Tool.






CAUTION:
Do not reuse rear oil seal.

Installation

Installation is the reverse order of removal.





- Drive the new oil seal straight until it stops using Tool.






CAUTION:
- Do not reuse rear oil seal.
- Apply multi-purpose grease to oil seal lips before installing.
- Do not incline rear oil seal during installation.

- Check the transmission oil level after installation. Refer to [M/T Oil: Checking] Procedures.