Air Breather Hose Removal and Installation

Air Breather Hose: Removal and Installation

Components










Removal

1) Disconnect air breather hose from breather tube and transmission connector.
2) Bend the clip away from the transmission housing and remove air breather hose.
3) Remove the clip bolt and remove the clip from the transmission housing, if necessary.
4) Remove the breather tube bolt and the breather tube.

Installation

Installation is in the reverse order of removal.

CAUTION:

- Make sure there are no pinched or blocked areas on the air breather hose after installation.
- When inserting the air breather hose, be sure to insert it fully until its end reaches the end of the tube radius.
- Install the air breather hose with the paint mark side up.
- Install the air breather hose and harness to the clip to prevent separation.
- Push the clip so that the harness contacts the clip bolt.