Removal and Replacement

Changing the A/T Fluid (ATF)

CAUTION:

If using the vehicle for towing, the A/T fluid must be replaced as specified. Refer to [Periodic Maintenance [for USA and Canada]] .

1) Drive the vehicle to warm up the A/T fluid to approximately 80 °C (176 °F).
2) Stop the engine.
3) Remove the A/T fluid level gauge.
4) Drain the A/T fluid from the drain plug hole, then install the drain plug with a new gasket. Refill the transmission with new A/T fluid. Always refill with the same volume as the drained A/T fluid. Use the A/T fluid level gauge to check the A/T fluid level as shown. Add A/T fluid as necessary.





Component





- To flush out the old A/T fluid from the transmission oil coolers, pour new A/T fluid into the A/T fluid charging pipe with the engine idling and at the same time drain the old A/T fluid from the auxiliary transmission oil cooler hose return line.
- When the color of the A/T fluid coming out of the auxiliary transmission oil cooler hose return line is about the same as the color of the new A/T fluid, flushing out the old A/T fluid is complete. The amount of new A/T fluid used for flushing should be 30% to 50% increase of the specified capacity.
[1][2]Maintenance





CAUTION:
- If SUZUKI approved Matic S ATF is not available, SUZUKI approved Matic J ATF may also be used. Using automatic transmission fluid other than SUZUKI approved Matic S ATF or Matic J ATF will cause deterioration in driveability and automatic transmission durability, and may damage the automatic transmission.
- When filling the transmission with A/T fluid, do not spill the A/T fluid on any heat generating parts such as the exhaust manifold.
- Do not reuse the drain plug gasket.

5) Install the A/T fluid level gauge and tighten the A/T fluid level gauge bolt to specification.
Component





6) Drive the vehicle to warm up the A/T fluid to approximately 80 °C (176 °F).
7) Check the fluid level and condition. If the A/T fluid is still dirty, repeat steps 2 through 6.





8) Install the A/T fluid level gauge in the A/T fluid charging pipe and install the A/T fluid level gauge bolt.
9) Tighten the A/T fluid level gauge bolt to specification.
Component