Programming and Relearning
ID Registration Procedure
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
- Activate and display TPMS transmitter IDs
- Display tire pressure reported by the TPMS transmitter
- Read TPMS DTCs
- Register TPMS transmitter IDs
ID Registration with Transmitter Activation Tool
NOTE:
This procedure must be done after replacement of a TPMS transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 or Signal Tech II Tool J-50190 before ID registration can be performed. Use the following procedure when using the Transmitter Activation Tool J-45295.
1) Connect SDT.
2) Select ID REGIST under BCM.
3) Push the transmitter activation tool against the tire near the front left transmitter. Press the button for 5 seconds.
4) Register the IDs in order from FR LH, FR RH, RR RH and RR LH. When ID registration of each wheel has been completed, the hazard warning lamps flash.
5) After completing all ID registrations, press END to complete the procedure.
NOTE:
Be sure to register all of the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnostic results display will not function properly.
ID Registration without Transmitter Activation Tool
NOTE:
This procedure must be done after replacement of a TPMS transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 or Signal Tech II Tool J-50190 before ID registration can be performed.
1) Connect SDT.
2) Select ID REGIST under BCM.
3) Adjust the tire pressures to the values shown in the table and drive the vehicle at 40 km/h (25 MPH) or more for a few minutes.
4) After completing all ID registrations, press END to complete the procedure.
5) Inflate all tires to proper pressure. Refer to [Service Data and Specifications] [1][2]Specifications.