Operation CHARM: Car repair manuals for everyone.
Home >> Suzuki Truck >> 2012 >> Equator 4WD V6-4.0L >> Repair and Diagnosis >> Powertrain Management >> Transmission Control Systems >> Relays and Modules - Transmission and Drivetrain >> Relays and Modules - Transfer Case >> Control Module >> Service and Repair

Control Module: Service and Repair




Transfer Control Unit: Removal and Installation

Removal

1) Switch 4WD shift switch to 2WD and set transfer assembly to 2WD.

CAUTION:
When removing transfer control unit, transfer state must be at 2WD.

2) Turn the ignition switch OFF and disconnect negative battery terminal.
3) Remove the instrument lower panel LH. Refer to [Instrument Lower Panel LH: Removal and Installation] Instrument Lower Panel LH.
4) Disconnect the two transfer control unit connectors.





5) Remove the transfer control unit bolts.
6) Remove the transfer control unit.

Installation

Installation is in the reverse order of removal.

- When installing the transfer control unit, tighten bolts to the specified torque.






- After the installation, check 4WD shift indicator pattern. If NG, adjust position between transfer assembly and transfer control unit. Refer to [Precaution for Transfer Assembly and Transfer Control Unit Replacement] Procedures.

pro multis · About Operation CHARM