Overhaul

Steering Column: Disassembly and Assembly










Disassembly

1) Remove the bolt from the upper joint, then remove the upper joint from the steering column assembly.
2) Remove the ignition switch tamper resistant self-shear screws, using a drill.
3) Remove the ignition switch from the steering column.

Assembly

Assembly is in the reverse order of disassembly.

CAUTION:

Any time the ignition switch has been removed and installed, the keys must be re-registered in the BCM. Refer to SDT operation manual.

NOTE:

Install new tamper resistant self-shear screws.





Inspection after Assembly

When the steering wheel does not turn smoothly, check as follows:
1) Check the steering column for the following:
- Damage to the column tube or bearings
- Wear around the seal edges
- Corrosion or pitting around the seal sliding area
Replace the steering column as an assembly, if necessary.

CAUTION:
- Do not exert any axial load or impact to the steering column.
- Replace the column if it is depleted of grease, worn, damaged, or if any scratches or coating separation is present on the shaft seal area.

2) If the vehicle has been in a collision, or if noises are heard coming from the steering column, check column length. If out of specification, replace the steering column as an assembly.
Steering Wheel and Column









3) Check the tilt device for proper operation range.
Steering Wheel and Column