B1015

DTC B1015: "PASS AIR BAG OFF" Indicator Light Circuit Failure

Wiring Diagram










DTC Will be Set When

The voltage at the "PASS AIR BAG OFF" indicator light circuit terminal "G46-10" does not match the commanded state of the warning light driver for specified time.

Flow Test Description

Step 2: Check for "METER" fuse blown.

Step 3: Check for "PASS AIR BAG OFF" indicator light circuit.

Step 4: Check for "PASS AIR BAG OFF" indicator light circuit.

Step 5: Check if malfunction is in center panel indicator included in HVAC control module.

DTC Troubleshooting

1.
Was "Air Bag Diagnostic System Check" performed?
YES -
Go to Step 2.
NO -
Go to Air Bag Diagnostic System Check Air Bag Diagnostic System Check:Advanced Air Bag.

2. Turn ignition switch OFF.
Remove and inspect "METER" fuse.

Is fuse good?
YES -
Go to Step 3.
NO -
"PPL/RED" wire short to ground. After repair, replace "METER" fuse.

3. Disconnect SDM connector "G46" and center console indicator connector "G61".
Check proper connection to SDM at terminal "G46-10" and center console indicator connector "G61-4".
Check "PASS AIR BAG OFF" indicator light circuit between "G46-10" and "G61-4" for open, short and high resistance.
Special Tool

(A): 09932-76010





Is it in good condition?
YES -
Go to Step 4.
NO -
Repair "BLK/BLU" circuit.

4. Check proper connection at "G03-11" terminal and center console indicator connector "G61-1".
Check "PASS AIR BAG OFF" indicator light circuit between "G61-1" and "G03-11" for open, short and high resistance.






Is it in good condition?
YES -
Go to Step 5.
NO -
Repair "PPL/RED" circuit.

5. Check center panel indicator included in HVAC control module.

Is it in good condition?
YES -
Substitute a known-good SDM and recheck.
NO -
Replace center panel indicator included in HVAC control module referring to HVAC Control Module Removal and Installation HVAC Control Module Removal and Installation. If DTC still exists, substitute a known-good SDM and recheck.

NOTE:

Upon completion of inspection and repair work, perform the following items.

- Reconnect all air bag system components and ensure all components are properly mounted.
- Clear DTCs, if any. DTC Clearance
- Repeat Air Bag Diagnostic System Check Air Bag Diagnostic System Check:Advanced Air Bag
to confirm that the trouble has been corrected.