B1046

DTC B1046: Passenger Air Bag (2nd Stage) Circuit Resistance Low

Wiring Diagram

Refer to B1045 DTC B1045: Passenger Air Bag (2nd Stage) Circuit Resistance High:Advanced Air Bag.

DTC Will be Set when

The combined resistance of the passenger air bag (inflator) module (2nd stage), harness wiring and connector terminal contact is below a specified value for specified time.

Flow Test Description

Step 2: Check if malfunction is in passenger air bag (inflator) module (2nd stage).

Step 3: Check passenger air bag (inflator) module (2nd stage) initiator circuit. (Between "Q01" and "Q03")

Step 4: Check passenger air bag (inflator) module (2nd stage) initiator circuit. (Between "G67" and "G46")

DTC Troubleshooting

1.
Was "Air Bag Diagnostic System Check" performed?
YES -
Go to Step 2.
NO -
Go to Air Bag Diagnostic System Check Air Bag Diagnostic System Check:Advanced Air Bag.

2. With ignition switch OFF, disconnect passenger air bag (inflator) module connectors.
Check proper connection to passenger air bag (inflator) module at terminals in "Q03" connector (connector color is black).
If OK, then connect special tools (A), (B) and (D) to "Q03" connector (connector color is black).
Special Tool

(A): 09932-76010

(B): 09932-75010

(D): 09932-78310





Check SDM DTC.

With ignition switch ON, is DTC B1046 indicated?
YES -
Go to Step 3.
NO -
Turn ignition switch OFF. Replace passenger air bag (inflator) module referring to Removal and Installation Passenger Air Bag (Inflator) Module Removal and Installation:Advanced Air Bag.

3. With ignition switch OFF, disconnect "G67" connector located near the glove box.
Check proper connection to instrument panel harness connector at terminal "G67-3" and "G67-4".
If OK, then connect special tools (B) and (C) to "G67" connector disconnected in Step 1).
Special Tool

(B): 09932-75010

(C): 09932-77320





Check SDM DTC.

NOTE:
At this time, DTC B1041 may be output, but it is not related to this check.

With ignition switch ON, is DTC B1046 indicated?
YES -
Go to Step 4.
NO -
"ORN/BLU" circuit shorted to "ORN/GRN" circuit, "ORN/BLU" circuit or "ORN/GRN" circuit shorted to other circuit. (Between "Q01" and "Q03" connectors)

4. With ignition switch OFF, disconnect SDM connector "G46".
Check proper connection to SDM at terminals "G46-13" and "G46-14".
If OK, release shorting bar in SDM connector inserting release tool (1) included in special tool (A).
Measure resistance between "G46-13" and "G46-14" terminals with connected special tools (B) and (C).
Special Tool

(A): 09932-76010

(B): 09932-75010

(C): 09932-77320





Is resistance 0.65 ohms or more?
YES -
Substitute a known-good SDM and recheck.
NO -
"ORN/BLU" circuit shorted to "ORN/GRN" circuit, "ORN/BLU" circuit or "ORN/GRN" circuit shorted to other circuit. (Between "G67" and "G46" connectors)

NOTE:

Upon completion of inspection and repair work, perform the following items.

- Reconnect all air bag system components and ensure all components are properly mounted.
- Clear DTCs, if any. DTC Clearance
- Repeat Air Bag Diagnostic System Check Air Bag Diagnostic System Check:Advanced Air Bag
to confirm that the trouble has been corrected.