B1361

DTC B1361 / B1365: Driver / Passenger Side Curtain-Air Bag Circuit Resistance High

Wiring Diagram










DTC Will be Set when

The combined resistance of the side curtain-air bag (inflator) module (driver or passenger), harness wiring and connector terminal contact is above a specified value for specified time.

Flow Test Description

Step 2: Check whether malfunction is in side curtain-air bag (inflator) module.

Step 3: Check side curtain-air bag initiator circuit.

DTC Troubleshooting

1.
Was "Air Bag Diagnostic System Check" performed?
YES -
Go to Step 2.
NO -
Go to Air Bag Diagnostic System Check Air Bag Diagnostic System Check:Advanced Air Bag.

2. With ignition switch OFF, remove rear side upper trim of left or right side and disconnect side curtain-air bag (inflator) module connector.
Check proper connection to side curtain-air bag (inflator) module at terminals in "L18" or "L41" connector.
If OK, then connect special tools (A), (B) and (C) to side curtain-air bag (inflator) module connector.
Special Tool

(A): 09932-76010

(B): 09932-75010

(C): 09932-78310





Check SDM DTC.

With ignition switch ON, is DTC B1361 or B1365 still indicated?
YES -
Go to Step 3.
NO -
Replace side curtain-air bag (inflator) module. Side Curtain-Air Bag (Inflator) Module Removal and Installation

3. With ignition switch OFF, disconnect SDM connector "L32".
Check proper connection to SDM at terminals "L32-1" and "L32-2" or "L32-3" and "L32-4".
If OK, release shorting bar in SDM connector inserting release tool (1) included in special tool (A).
Measure resistance between "L32-1" and "L32-2" terminals (for DTC B1361) or "L32-3" and "L32-4" terminals (for DTC B1365) with connected special tools (A), (B) and (C).
Special Tool

(A): 09932-76010

(B): 09932-75010

(C): 09932-78310





Is resistance 5.5 ohms or less?
YES -
Substitute a known-good SDM and recheck.
NO -
DTC B1361: Repair high resistance or open in "YEL/GRN" or "YEL/BLU" wire circuit.
DTC B1365: Repair high resistance or open in "BLK/YEL" or "BRN/YEL" wire circuit.

NOTE:

Upon completion of inspection and repair work, perform the following items.

- Reconnect all air bag system components, ensure all components are properly mounted.
- Clear DTCs, if any. DTC Clearance
- Repeat Air Bag Diagnostic System Check Air Bag Diagnostic System Check:Advanced Air Bag
to confirm that the trouble has been corrected.