P0575

DTC P0575: Cruise Control Input Circuit

Wiring Diagram

Refer to P0504 DTC P0504: Brake Switch "A"/"B" Correlation.

DTC Detecting Condition and Trouble Area






DTC Confirmation Procedure

1) With ignition switch turned OFF, connect scan tool to DLC.
2) Turn ON ignition switch and clear DTC.
3) Start engine and warm up to normal operating temperature.
4) Press cruise MAIN (ON/OFF) switch once.
5) Drive vehicle at 40 km/h (25 mph) or higher for 3 min. or more.
6) Stop vehicle.
7) Check DTC.

DTC Troubleshooting

NOTE:

Before performing the above-mentioned troubleshooting, read and observe Precautions for DTC Troubleshooting Precautions for DTC Troubleshooting.

1. Cruise control switch check

Check cruise control switch referring to Cruise Control Switch Inspection Cruise Control Switch Inspection.

Is it in good condition?
YES -
Go to Step 2.
NO -
Replace cruise control switch.

2. Cruise control MAIN (ON/OFF) switch and command switch circuit check

Disconnect connectors from ECM with ignition switch turned OFF.
Check for proper connection of cruise control switch circuit terminal to ECM connector.
If connections are OK, check the following for cruise MAIN (ON/OFF) switch and command switch circuit.
- Voltage of between "BLK/WHT" wire terminal of cruise control switch connector and vehicle body ground is 0 V with ignition switch turned ON (power short check)
- Resistance between "LT GRN" wire terminal and "BLK/YEL" wire terminal of cruise control switch connector are infinity (no continuity check)
- Resistance between "LT GRN" wire terminal of cruise control switch connector and vehicle body ground is infinity (ground short check)

Is it in good condition?
YES -
Substitute a known-good ECM and recheck.
NO -
Repair or replace wire circuit.