P0717

DTC P0717: Input / Turbine Speed Sensor "A" Circuit No Signal

Wiring Diagram










DTC Detecting Condition and Trouble Area






DTC Confirmation Procedure

1) Connect scan tool to DLC with ignition switch OFF.
2) Clear DTCs in TCM and ECM memories by using scan tool.
3) Start engine and shift select lever to "D" range.
4) Start vehicle and increase vehicle speed to about 40 km/h (25 mile/h) for 3 minutes or more.
5) Stop vehicle.
6) Check DTC, pending DTC and freeze-frame data.

DTC Troubleshooting

1.
Was "A/T System Check" performed?
YES -
Go to Step 2.
NO -
Go to A/T System Check A/T System Check.

2. Check input shaft speed sensor circuit

Disconnect TCM connectors with ignition switch OFF.
Check for proper connection to input shaft speed sensor at "E93-6" and "E93-16" terminals.
If OK, check resistance of sensor circuit.

Resistance of input shaft speed sensor circuit
Between terminals "E93-6" and "E93-16" of disconnected harness side TCM connector: 560 - 680 ohms at 20 °C (68 °F)
Between terminals "E93-16" of disconnected harness side TCM connector and ground: No continuity

Are check results satisfactory?
YES -
Go to Step 4.
NO -
Go to Step 3.

3. Check input shaft speed sensor

Check input shaft speed sensor referring to Input Shaft Speed Sensor Inspection Input Shaft Speed Sensor Inspection.

Is check result satisfactory?
YES -
Input shaft speed sensor circuit is malfunction.
NO -
Go to Step 4.

4. Check visually input shaft speed sensor and clutch drum using mirror for following

- No damage
- No foreign material attached
- Correct installation






Are they in good condition?
YES -
Intermittent trouble. Check for intermittent trouble referring to Intermittent and Poor Connection Inspection Intermittent and Poor Connection Inspection.
NO -
Clean, repair or replace.