Body Control Module: Service and Repair

BCM Removal and Installation

Removal

1) Disconnect negative cable from battery.
2) Remove steering column hole cover (1).
3) Disconnect connectors from BCM.
4) Remove BCM (2).






Installation

Reverse removal procedure for installation, noting following point.

- Connect connectors securely until it clicks.
- If BCM is replaced of vehicle equipped with TPMS, register ID code of tire pressure sensor into the BCM. Refer to Registration Procedure for Tire Pressure Sensor ID Code Registration Procedure for Tire Pressure Sensor ID Code.
- With keyless entry system (non-keyless start model), if BCM is replaced, register transmitter code into BCM, referring to Testing and Inspection Programming Transmitter Code for Keyless Entry System (Other than Keyless Start Model).