Advanced Air Bag
Side-Air Bag (Inflator) Module Removal and Installation
WARNING:
Failure to take proper precautions when performing service on the side-air bag (inflator) module can result in personal injury or non-activation of the air bag in the event of a collision.
- Never attempt to disassemble or repair an air bag (inflator) module. If any abnormality is found, replace the module with a new one.
- Carefully read Precautions on Service and Diagnosis of Air Bag System Precautions on Service and Diagnosis of Air Bag System:Advanced Air Bag
, Precautions on Handling and Storage of Air Bag System Components Precautions on Handling and Storage of Air Bag System Components:Advanced Air Bag
and Precautions on Disposal of Air Bag and Seat Belt Pretensioner Precautions on Disposal of Air Bag and Seat Belt Pretensioner:Advanced Air Bag
and follow all of the instructions provided.
Removal
1) Disable air bag system. Refer to Disabling Air Bag System Disabling Air Bag System:Advanced Air Bag.
2) Roll up the seat surface of the seat back.
3) Remove sleeve lock nut (1) from seat back (2).
4) Remove side-air bag (inflator) module from seat back.
5) Disconnect side-air bag (inflator) module connector (1) as shown in the figure.
a) Unlock lock button (2).
b) With lock button unlocked, disconnect connector.
WARNING:
Failure to take proper precautions when handling and storing a live (non-deployed) air bag (inflator) module can result in personal injury due to accidental deployment of the air bag.
- Always carry a live air bag (inflator) module with the air bag's opening pointed away from you. Doing so will help reduce the chance of injury in case of accidental deployment of the air bag.
- Never carry an air bag (inflator) module by the wires or connector on the side of the module.
- Always place a live air bag (inflator) module with the bag (trim cover) side facing up when it is stored or left standing. Allowing for a free space above the module is essential to minimize the risk of personal injury in the event of accidental deployment of the air bag.
- Carefully read Precautions on Handling and Storage of Air Bag System Components Precautions on Handling and Storage of Air Bag System Components:Advanced Air Bag
and follow all of the instructions provided.
NOTE:
In order to install the side-air bag to the seat back correctly, do not damage the sleeve.
Installation
Side-Air Bag (Inflator) Inspection:Advanced Air Bag
1) Confirm sleeve (1) is surely installed in side-air bag (inflator) module.
2) Tighten sleeve lock nut (2) to specified torque.
Tightening torque
Sleeve lock nut (a): 2.5 Nm (0.25 kgf-m, 2.0 lbf-ft)
3) Install new clip to seat back.
4) Connect side-air bag (inflator) module connector (1) securely as shown in the figure.
a) Connect connector.
b) Lock connector with lock button (2).
5) Insert claw (1) of side-air bag (inflator) module on installation hole (2).
6) Push side-air bag (inflator) module into clip (3) with specified force.
Side-air bag (inflator) module installation force
Pushing force: 180 N
