Advanced Air Bag

"AIR BAG" Warning Light Does Not Come ON

Wiring Diagram

Refer to AIR BAG Warning Light Comes ON Steady "AIR BAG" Warning Light Comes ON Steady:Advanced Air Bag.

Flow Test Description

Step 2: Check combination meter power feed circuit.

Step 3: Check "AIR BAG" warning light circuit.

Troubleshooting

1.
Was "Air Bag Diagnostic System Check" performed?
YES -
Go to Step 2.
NO -
Go to Air Bag Diagnostic System Check Air Bag Diagnostic System Check:Advanced Air Bag.

2. Set parking brake.
Note combination meter when ignition switch is turned ON.

Does the "BRAKE" indicator (warning light) come ON?
YES -
Go to Step 3.
NO -
Check and correct the following possible cause. - Open circuit in "BLK/YEL" or "PPL/RED" wire. - Short circuit between "BLK/YEL" or "PPL/RED" and ground. - "METER" fuse blown.

3. Disconnect SDM connector "G46".
Note combination meter when ignition switch is turned ON.

Does the "AIR BAG" warning light come ON?
YES -
Substitute a known-good SDM and recheck.
NO -
"YEL/BLK" circuit shorted to power circuit. If OK, replace combination meter.

NOTE:

Upon completion of inspection and repair work, perform the following items.

- Reconnect all air bag system components and ensure all components are properly mounted.
- Repeat Air Bag Diagnostic System Check Air Bag Diagnostic System Check:Advanced Air Bag
to confirm that the trouble has been corrected.