Connecting Rod, Engine
Connecting Rod
Tightening torque
Connecting rod bolt* (a): (15 Nm -> +45° -> +45° (1.5 kgf-m -> +45° -> +45°, 11.0 lbf-ft -> +45° -> +45°)
NOTE:
Tighten connecting rod bearing cap bolt (3) gradually.
a) Point arrow mark (2) on connecting rod bearing cap (1) to crankshaft pulley side.
b) Apply engine oil to bolt thread and seat of connecting rod bearing cap bolt.
c) Tighten all connecting rod bearing cap bolt to 15 Nm (1.5 kgf-m, 11.0 lbf-ft) evenly and gradually.
d) In the same manner as Step c), retighten them to 45°.
e) In the same manner as Step c), retighten them to 45°.
Piston pin clearance
Piston pin clearance in connecting rod small-end
Standard: 0.003 - 0.017 mm (0.0002 - 0.0006 in.)
Limit: 0.040 mm (0.0015 in.)
Piston pin clearance in piston
Standard: 0.010 - 0.016 mm (0.00040 - 0.00062 in.)
Limit: 0.05 mm (0.0019 in.)
Small-end bore 21.003 - 21.011 mm (0.82689 - 0.83720 in.)
Piston pin outside diameter 20.994 - 21.000 mm (0.82654 - 0.82677 in.)
Diameter of piston pin hole in piston 21.007 - 21.013 mm (0.82705 - 0.82728 in.)
Big-end side clearance
Big-end side clearance
Standard: 0.25 - 0.40 mm (0.0099 - 0.0157 in.)
Connecting rod alignment
Limit on bow: 0.05 mm (0.0019 in.)
Limit on twist: 0.10 mm (0.0039 in.)
Connecting rod big-end inside diameter