Control Rod / Bushing Disassembly and Reassembly

Control Rod / Bushing Disassembly and Reassembly

Control Rod Removal and Installation

Disassembly

1) Push out control rod bushing by using hydraulic press (1) and special tool.
Special Tool

(A): 09913-84510





Reassembly

1) Press-fit control rod bushing (1) by using press (2) and special tool.

NOTE:
Any removed bushing will not fit properly if you reuse it.

Always use a new bushing.

Special Tool

(A): 09913-85210





2) Press-fit bushing so that dimensions "A" and "B" in figure become equal.