Flywheel / Drive Plate Removal and Installation

Flywheel / Drive Plate Removal and Installation

Removal

1) Remove transmission assembly.
- M/T model: Removal and Replacement
- A/T model: Removal and Replacement
2) Wedge a special tool in ring gear teeth to lock flywheel or drive plate as shown in figure.
Special Tool

(A): 09924-17811





3) Remove flywheel or drive plate from engine assembly.

Installation

Reverse removal procedure noting the following.

- Install new drive plate bolts or flywheel bolts.
- Wedge a special tool in ring gear teeth to lock flywheel or drive plate as shown in figure.
Special Tool

(A): 09924-17811

- Tighten flywheel bolts or drive plate bolts to specified torque.

Tightening torque
Flywheel bolt (a): 70 Nm (7.1 kgf-m, 52.0 lbf-ft)
Drive plate bolt (a): 70 Nm (7.1 kgf-m, 52.0 lbf-ft)