Disassembly and Reassembly

Output Shaft Disassembly and Reassembly

Manual Transmission Unit Disassembly

Disassembly

1) Remove output shaft rear snap ring.
2) Apply bearing puller to output shaft front bearing (1), and drive out output shaft front bearing, output shaft gear (2) and output shaft rear bearing (3) all at once from output shaft using hydraulic press.






Reassembly

Output Shaft Inspection
1) Clean all components thoroughly, inspect them for any abnormality and replace with new ones as necessary.
2) Put front bearing (1) onto output shaft facing groove (4) side to output shaft gear (2) and drive in output shaft front bearing, output shaft gear and output shaft rear bearing (3) all together using special tool and hydraulic press.
Special Tool

(A): 09940-51710





3) Install new output shaft rear snap ring.