Fuel Cut Operation

Shorting Idle Switch For Fuel Cut Inspection:

NOTE: Before inspection, check to make sure that gear shift lever is in neutral position (with A/T model, selector lever in "P" range), A/C is OFF and that parking brake lever is pulled all the way up.


1. Warm up engine to normal operating temperature.

2. Remove rubber seal from TS or TPS.

3. Using service wire, connect "A" and "S" terminals (idle switch terminal) of coupler from wire side.

4. Gradually raise engine speed. It should show variation (up and down) around 2,000 rpm.

5. After checking, disconnect service wire and install rubber seal to coupler.