Stop Light Switch - Modification
TSB No. TS 007 11223Section Title: All Models
Division: Automotive
Category: Technical
SUBJECT:
MODIFICATION OF STOP LIGHT SWITCH
MODEL: ALL MODELS
YEAR:
AUGUST 1993 PRODUCTION AND LATER
CONDITION:
Modification of Stop Light Switch.
CAUSE:
Factory modification.
CORRECTION:
Modify applicable section in Service Manual for future reference.
This bulletin is to inform you of the modification of the Stop Light Switch which has been carried out since August 1993 production in Japan and October 1993 production in Canada. The Stop Light Switch "ON-OFF" shift point has been modified, as shown.
Due to this modification, Section 5 of the existing Service Manual should also be changed regarding clearance "a" for stop light switch adjustment, as follows:
2. STOP LIGHT SWITCH ADJUSTMENT
Adjustment should be made as follows when installing switch. Pull up brake pedal toward you and while holding it there, adjust switch position so that clearance between end of thread and brake pedal return cushion (shown as "a" in figure) is within specification. Then tighten lock nut to specified torque
Clearance "a":[1.5 - 2.0 mm (0.404 - 0.07 in.)]
Tightening Torque (a): 10 - 15 N-m (1.0 - 1.5 kg-m, 7.5 - 10.5 lb.ft.)
PARTS SUPPLY DATA