Installation

- For remounting, reverse dismounting procedure. Use specified torque as given.

NOTE: Apply grease to gear shift control shaft bushes, however, DO NOT lubricate extension rod bush.

CAUTION:
^ Care should be taken not to scratch oil seal lip with drive shaft while raising transmission.
^ Do not hit drive shaft joint with hammer when installing it into differential gear.

- Push in left side drive shaft joint fully so as to snap ring of shaft engages with differential gear.
- Set each clamp for wiring securely.





- After connecting clutch cable, be sure to adjust its play properly.

Arm play "a": 0 - 2 mm (0 - 0.08 inch)
[Pedal play "a": 15 - 20 mm (0.6 - 0.8 inch)]

- Fill transmission with oil as specified.
- Connect battery and check function of engine, clutch and transmission.