Air Bag - Disable Procedure

TSB No.: TS 010 11214
Section Title: General Tech Info

Division: Automotive
Category: Technical

SUBJECT:
AIR BAG SYSTEM ENABLE/DISABLE PROCEDURE

MODEL:
ALL MODELS WITH AIR BAG SYSTEM

YEAR:
1995

CONDITION:
Necessary to disable air bag system before repairs and enable after repairs.

CAUSE:
Prevent accidental air bag deployment, personal injury or unneeded air bag repairs.

CORRECTION:
Follow procedure listed below.

The SDM (Sensing and Diagnostic Module) can maintain sufficient voltage to cause a deployment of air bag for up to ten (10) seconds after the ignition switch is turned to the "LOCK" position, the battery is disconnected or the fuse powering the SDM is removed. Many of the service procedures require disconnection of the "AIR BAG-IG" fuse and the air bag (inflator) modules (driver and passenger) from the deployment loop to avoid accidental deployment. Diagnostic procedures do not normally require fuse removal or disconnection of air bag (inflator) modules.

WARNING:
When performing service on or around air bag system components or air bag wiring, follow the procedures listed in this bulletin to temporarily disable the air bag system. Refer to appropriate service manual procedures. Failure to follow procedures could result in possible air bag deployment, personal injury or unneeded air bag system repairs.

DISABLING AIR BAG SYSTEM





1. Turn steering wheel so that the vehicle's wheels (front tires) are pointing straight ahead.

2. Turn ignition switch to "LOCK" position and remove key.

3. Remove "AIR BAG-IG" fuse from air bag fuse box located near the junction/fuse block.

4. Remove steering wheel side cap (left) and disconnect Yellow connector of driver air bag (inflator) module.

5. Pull out the glove box while pushing its stopper from both right and left sides and disconnect Yellow connector of passenger air bag (inflator) module.

NOTE:
With "AIR BAG-IG" fuse removed and ignition switch ON, "AIR BAG" warning lamp will be ON. This is normal operation and does not indicate a air bag system malfunction.

ENABLING AIR BAG SYSTEM





1. Turn ignition switch to "LOCK" and remove key.

2. Connect Yellow connector of passenger air bag (inflator) module and Yellow connector of the driver air bag (inflator) module respectively, and be sure to lock each connector with lock lever.

3. Install the glove box and steering wheel side cap.

4. Install "AIR BAG-IG" fuse to air bag fuse box.

5. Turn ignition switch to "ON" and verify that "AIR BAG" warning lamp flashes seven (7) times and then turns off. If it does not operate as described, perform the "Air Bag Diagnostic System Check" outlined in the appropriate service manual, Section 9J.