Disassembly

1. Remove valve body assembly from transmission case.
2. Pull out manual valve.





3. Remove solenoids by removing bolts.





4. Remove 11 bolts from valve body front side.





5. Remove 5 bolts from valve body rear side.
6. Remove rear valve body gaskets and separator plate together with rear valve body.

NOTE: Never reuse gasket after removal.








7. Remove six balls, oil solenoid strainer and check valves and compression springs.





8. Remove check valve and compression spring from front valve body.





9. Remove following parts and springs by removing rear valve body cover bolts and key.
1) Rear valve body cover
2) Gasket
3) Plate
4) Forward clutch accumulator
5) Overdrive clutch accumulator
6) 2 - 3 timing valve
7) Coast clutch modulator
8) TCC control valve
9) 2nd and 4th brake accumulator
10) Reverse clutch accumulator
11) Solenoid modulator valve
12) Low coast modulator valve
13) 2nd and 4th brake modulator control valve
14) Secondary regulator valve





10. Remove following parts from front valve body by removing keys.
1) 2nd and 4th brake modulator
2) Accumulator control valve
3) Primary regulator valve
4) Key





11. Remove front valve body cover, cover gaskets and plate by removing 4 bolts.

NOTE: Never reuse used gasket.

12. Remove check valve, compression spring, three balls and oil solenoid strainers.





13. Remove following parts from front valve body by removing keys.
1) 1 - 2 shift valve
2) 2 - 3 shift valve
3) 3 - 4 shift valve
4) TCC modulator valve
5) Key