Output Shaft: Service and Repair

OUTPUT SHAFT BEARINGS

REMOVAL





1. Remove cover side bearing. Hold output shaft with soft jawed vise and remove bearing by using bearing puller.





2. Install inside bearing. Hold bearing by using bearing puller and drive out shaft with press.

CAUTION: Never hit shaft end where seal ring is installed so as not to distort ring slit.

INSTALLATION





1. Install inside bearing. Use special tool with press.
Special Tool (A): 09913-85210 or equivalent.





2. Install cover side bearing. Hold shaft at parking lock gear and press-fit bearing by using special tool with press.
Special Tool (B): 09944-66020 or equivalent.