Component Parts Installation

CAUTION:
^ Automatic transmission consists of highly precise parts. As even a flaw in a small part may cause oil leakage or decrease in function, check each part carefully before installation.
^ Clean all parts with compressed air. Never use wiping cloths or rags.
^ Before assembling new clutch discs and brake band, soak them in automatic transmission fluid for at least hours hours.
^ Be sure to use new gaskets and O-rings.
^ Lubricate O-rings with automatic transmission fluid.
^ Apply automatic transmission fluid on sliding or rotating surfaces of the parts before assembly.
^ Use yellow petrolatum grease or SUZUKI super grease C to retain parts in place.
^ Be sure to install thrust bearings and races in correct direction and position as shown in figure.





^ Make sure that snap ring ends are not aligned with one of cutouts and are installed in groove correctly.
^ Do not use adhesive cements on gaskets and similar parts.
^ Be sure to torque each bolt and nut to specification.