Manual Road Test

MANUAL ROAD TEST
This test checks the gears being used in L, 2 or D range when driven with unoperated gear shift control system. Test drive vehicle on a level road.
1. With selector lever in P start engine and warm it up.





2. After warming up engine, disconnect coupler of solenoid valve wire as shown in figure.
3. With selector lever in L range, start vehicle and accelerate to 30 km/h (19 mile/h). Check in this state that 1st gear is being used.
4. At 30 km/h (19 mile/h), shift selector lever to 2 range and accelerate to 60 km/h (37 mile/h). Check in this state that 2nd gear is being used.
5. At 60 km/h (37 mile/h), shift selector lever to D range and check that 3rd gear is used when speed is higher than 60 km/h (37 mile/h).
6. After above checks, stop vehicle then engine, and connect solenoid valve wire coupler.
7. Clear DTC with scan tool.