Clearing Trouble Codes

DIAGNOSTIC TROUBLE CODE (DTC) CLEARANCE
All DTC's are cleared only by performing following Steps 1) to 4) in that order.
1) Turn ignition switch OFF.




2) Using service wire, connect diag. switch terminal of DIAG-2 connector to diag. output terminal.
3) With connection described above maintained, turn ignition switch ON and leave it as it is for longer than 10 seconds.
4) Turn ignition switch OFF and disconnect service wire from DIAG-2 connector.
5) Perform "DTC check" and confirm that normal DTC (DTC 12) is displayed and not malfunction DTC.

NOTE: It is also possible to clear DTC by using Tech-1. Refer to Cartridge Manual for procedure to clear DTC.