Front Stabilizer Bar

REMOVAL
1. Remove stabilizer link nuts, washers and cushions.
2. Remove stabilizer mount brackets.
3. Remove stabilizer.
4. Remove stabilizer joints from stabilizer.





INSTALLATION
1. When installing stabilizer, loosely assemble all components while insuring that stabilizer is centered, side-to-side. Refer to figure (A) for its check.

NOTE: For correct installation of stabilizer bar, side-to-side, be sure that color paint on stabilizer bar aligns with mount bush, both right and left, as shown.

For correct installation in vertical direction, refer to figure (B).

2. Install parts by reversing Steps 1. - 3. of REMOVAL. Refer to figure.

Tightening Torque:
(a): 40 - 60 Nm (29.0 - 43.0 ft. lbs.)
(b): 20 - 30 Nm (14.5 - 21.5 ft. lbs.)
(c): 22 - 33 Nm (16.0 - 23.5 ft. lbs.)