Evaporative Emission Control Canister: Service and Repair

REMOVAL




1. Hoist vehicle.
2. Remove muffler referring to "Exhaust system" section.
3. Disconnect tank hose, purge hose and refuel vapor control valve hose from EVAP canister.

For quick joint, disconnect it as follows:
1. Remove mud or dust around joint by blowing compressed air, and push joint fully in arrow direction.
2. Disconnect hose joint while joint lock is unlocked by pushing both sides of joint.

4. Remove EVAP canister bolts.
5. Disconnect air valve hose from EVAP canister.
6. Remove rear stabilizer mount brackets.
7. Support suspension frame with a suitable hydraulic jack and loosen suspension frame bolts until each bolt projects about 2 cm (0.8 in.).
8. Lower suspension frame and take out EVAP canister.

INSTALLATION




1. Connect air valve hose to EVAP canister.
2. Install EVAP canister to rear suspension frame.
3. Connect tank hose, purge hose and refuel vapor control valve hose to EVAP canister, and clamp then securely.
For quick joint, push joint into pipe till joint lock clicks.