Coast/Set, Resume/Accel and Cancel Switches

These switches are built in the combination switch assembly.

CAUTION: Never disassemble combination switch will spoil its original functions.

INSPECTION




1. Disable air bag system.
2. Disconnect connector of COAST/SET, RESUME/ACCEL and CANCEL switches.
3. Check for resistance between "Gr" and "R" wire terminals of disconnected switch connector under each condition below.

All switches released (OFF) : Infinity
CANCEL switch pressed (ON) : About 0 ohm
COAST/SET switch rotated (ON) : 200 - 240 ohm
RESUME/ACCEL switch rotated (ON) : 820 - 1000 ohm

If check result is not satisfactory, replace combination switch assembly.