Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION SENSOR

Removal
1) Hoist vehicle.
2) Remove fender apron extension on right side.





3) Disconnect connector from crankshaft position sensor.





4) Remove crankshaft position sensor from oil pan.

Installation
1) Check to make sure that crankshaft position sensor and pulley tooth is free from any metal particles and damage.
2) Install crankshaft position sensor to oil pan.

Tightening Torque
(a): 10 N.m (1.0kg-m, 7.5 lb-ft)

CAUTION: Be sure to tighten to specified torque. CKP sensor will be deformed if overtightened and correct CKP sensor signal will not be fed if loosened.

3) Connect connector to it securely.
4) Install fender apron extension.