P0125

Wiring Diagram:

CIRCUIT DESCRIPTION
Refer to ECT Sensor Operation.

Detecting Condition / Possible Cause:

DTC CONFIRMATION PROCEDURE

WARNING:
- When performing a road test, selects place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester.

1. Turn ignition switch OFF. Clear DTC with ignition switch ON, check vehicle and environmental condition for:
- Indication of fuel level meter in combination meter: 1/4 or more
- Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)
- Ambient temp.: -10 °C, 14 °F or higher
- Intake air temp.: 70 °C, 158 °F or lower

2. Drive vehicle at 30 - 40 mph, 50 - 60 kph for 5 min. (or till engine coolant temperature rises to 40 °C, 104 °F or higher.)
3. Stop vehicle (do not turn ignition switch OFF).
4. Check DTC in "DTC" mode and pending DTC in "ON BOARD TEST" or "PENDING DTC" mode.

Inspection (Steps 1 - 3):